Introduction of Maintenance Method for Wired Beam Connectors after Burned

Most of the burned parts are connected to the place where the plug is connected, and heat is generated to burn the connector plastic plug. Generally, the burned wire harness is a headlight wire bundle, a cigarette lighter wire bundle, etc.. Overloaded wires, replacing the entire car wire harness take time and effort, The following is a description of the repair and repair plan for the car cable plug processing:
1. Find a piece of paper or use a camera to record the position of the wire beam. Use a thin steel pin to gently stab the wire beam terminal, so that all wire beam terminals are separated from the burned plug. The burned place is not easy to poke out. Pull it down directly. This is the first step;
2. Purchase of connectors(ie, cable plugs) and wiring terminals, special wire cutters for wire bundles, and hot shrink sleeves at the manufacturer of car wire harness processing;
3. Clear the burned area of the burned wire beam, and the hot contraction sleeve is tailored to fit on it. The wire bundle is connected and the wiring terminal is fixed with a pressure wire clamp into the connector, and the hot water is used to heat the hot contraction band. The hot shrink sleeve can wrap the copper wire tightly, and with this maintenance method is the same as the new.
Summary: The processing of wire bundles in this way can save the time to replace the entire car wire harness, save the cost of purchasing the car wire harness, and is simple and practical. The car wire harness plugs for maintenance, wire harness terminals, and pressing wire pliers can be purchased directly from the car wire harness manufacturer.