Production Technology of Automobile Wire Beam Arranging Wire Beam

After the two-dimensional product drawings of the car wire beam come out, the production process of the wire beam must be arranged. The process is inseparable from the production. Therefore, the production of the car wire beam and the technology are combined to analyze together.
The second position after the line is the pressing process. According to the type of terminal required by the drawing, the pressing parameters are determined, and the manual of pressing operation is produced. The special requirements for the lamp socket need to be noted and trained on the process document. For example, some wires need to pass through the guard before they can be pressed. The car audio wire beam needs to be preloaded with wires before returning from the preloading position; There is also a special pressing tool for puncture type pressing, which has good electrical contact performance.
Then is the preloading process, first of all to prepare the pre-loading process operation manual, in order to improve the assembly efficiency, complex wire harness must be set up pre-loading work, the reasonable or not of the preloading process directly affects the efficiency of the total assembly also reflects a The technical level of the personnel. If the preassembly part is less assembled or the route of the assembled wire is irreconcilable to increase the workload of the total assembly personnel, slow down the speed of the assembly line so that the process personnel must often stay at the scene and continue to summarize.
The final step is the assembly process. Ability to design assembly panel according to connector insert product development department, design assembly equipment, material box size, and attach all assembly covers and accessories numbers to material boxes to improve assembly efficiency. Compile the assembly content and requirements of various workspaces, balance the overall assembly position to prevent a bit of workload and pull down the speed of the entire assembly line. In order to achieve the balance of work, the process personnel must be familiar with each operation and measure the working hours on the spot, and adjust the assembly process at any time.